Garage Door Opener Repair in PG County
Remote won’t work, motor grinds, trolley slides but the door doesn’t move — opener problems are usually a 20-minute diagnosis. The licensed techs we dispatch repair every major opener brand across PG County.
Same-Day Service
24/7 Dispatch Line
One call, day or night. No forms, no waiting for callbacks.
Silence, Grinding or Half-Moves
The opener is the muscle, but it’s also the electronics: motor, gear set, logic board, safety sensors, limit switches and receiver. Nine out of ten ‘dead opener’ calls trace to a worn part or a sensor problem — not the whole unit.
Stripped Gears
The classic: opener runs, makes noise, door doesn’t move. The nylon main gear stripped — a common same-day fix on older Chamberlain/LiftMaster units.
Photo-Eye Sensor Faults
Bumped, dirty or misaligned safety sensors make doors refuse to close or reverse mid-cycle. Frost and condensation cause it all winter.
Logic Board & Capacitor Failures
Surges after summer storms kill boards and start capacitors. Signs: lights blink, opener hums, or it works only sometimes.
Remote & Receiver Problems
Dead remotes after battery swaps usually mean the receiver lost its pairing — or the wall button wiring, not the opener.
Stop Using the Door Until a Tech Looks at It
Every extra cycle with a damaged component makes the repair bigger. The 24/7 dispatch line routes a licensed, insured technician to you — same day in most cases across PG County.
The Repair, Step by Step
What actually happens on a same-day visit.
- Full diagnosis first. The tech tests wall button, remotes, sensors, limits and gear set to find the actual failure — the door’s balance is checked too, since a heavy door kills openers.
- Gear and sprocket replacement. Stripped gear kits are stocked for the major brands and take under an hour on most units.
- Sensor realignment. Photo-eyes get cleaned, re-aligned and tested with the door closing on a test object.
- Force and limit adjustment. Travel limits and force settings are reset so the door closes fully and reverses on a 2×4 laid flat — the standard safety test.
If the opener is 15+ years old and the board is dead, the tech quotes a replacement unit instead of a board repair — new openers add security features and phone control.
/garage-door-services/ | /service-areas/ | /emergency-garage-door-repair/ | /garage-door-spring-repair/
Garage Door Questions, Answered
Why does my garage door opener run but the door doesn’t move?
Usually a stripped main drive gear — the motor runs but nothing transfers. It’s one of the most common opener repairs and is typically a same-visit fix on older Chamberlain, LiftMaster and Genie units.
Why does my garage door open but won’t close?
Almost always the photo-eye safety sensors — dirty lenses, misalignment, or a wiring nick. The opener’s lights usually blink a code pattern to confirm it.
How long should a garage door opener last?
10-15 years on average, less if the door has been running heavy or the springs were worn. When an opener reaches that range and needs a board, replacement is usually the smarter call.
Should I repair or replace my opener?
The tech quotes both. Gear and sensor repairs make sense on units under 10 years old; dead logic boards on 15-year-old units usually don’t. You approve the number before any work.
Opener Acting Up? Get It Diagnosed Today
Most opener failures are a single worn part — a fast, same-day fix. Call the 24/7 line and describe the symptom; the tech arrives with the common parts.
Disclaimer: PG County Garage Door Repair is a free referral service to assist homeowners in connecting with local garage door technicians. All technicians are independent, and PG County Garage Door Repair does not warrant or guarantee any work performed. It is the responsibility of the homeowner to verify that the hired technician is properly licensed and insured for the work performed. This site is not affiliated with any government agency.